Much like everyone else, I get distracted and need to clean off my desk from time to time.  In doing so, I discovered my nice little relay circuit board that needed some rewiring after it was tweaked for a small issue that made me pull it.  The old wiring that was used previously was thicker and hard to manipulate.  This made working on the boards hard and more difficult than needed.  On top of that, the wiring was slightly too large for the connections on the boards.  I grabbed some wiring I had from the skateboard instead of strapping 100% of the wiring so now everything should work a lot nicer.  The new wiring is a smaller gauge and is far more flexible.

This project would be far higher of a priority if I lived in Seattle or Chicago, no doubt.